A deck can look like it just needs a good wash until you get close and notice peeling stain, splintered boards, or a surface you can’t identify. Those details matter before a pressure washer comes out.
If you’re asking me to clean a deck, tell me what you know about the boards and what you want to do afterward. Getting it ready for a cookout and preparing for a new finish can involve different work. If you’re hoping to keep the current stain, mention that before we discuss how to clean it.
Start with the material
Is it wood or composite? If it’s composite, do you know the brand or product line? A receipt, leftover board, or installation paperwork can help.
Even one brand may have different instructions for different generations of decking. Trex, for example, advises against using a pressure washer on its early-generation products. Its current care guidance has separate instructions for other product lines.
Check the Trex care and cleaning guide if that’s what you own. For another brand, use that manufacturer’s instructions. A cleaning video showing a similar-looking deck isn’t enough to identify yours.
With wood, look at the boards and the finish
Tell me about soft spots, loose boards, splinters, and areas that stay damp. If a board or railing is unsafe, get it repaired before cleaning. Don’t step onto a questionable area to take a photo.
If the deck has paint, stain, or a sealer, I need to know what’s there and what condition it’s in. A peeling finish can still be peeling after the dirt is gone. Weathered wood can still show its age.
Using too much pressure can damage wood fibers and leave marks. The plan needs to account for the boards, the existing finish, and the result you’re after.
Cleaning and refinishing need separate conversations
If you plan to stain or seal the deck, say so when asking for an estimate. A maintenance wash doesn’t automatically include stripping an old coating, sanding, repairs, or applying a new finish.
We should be clear about what the cleaning includes and what still needs doing afterward. Follow the coating manufacturer’s preparation and drying requirements before applying anything new. A deck that looks dry on top isn’t, by itself, proof that it’s ready for a coating.
That distinction also helps when comparing prices. Two estimates may be describing very different amounts of work.
What about the dark spots?
Send a close-up and a wider picture. Food and grease near the grill, leaf marks, general buildup, and an old coating issue aren’t necessarily the same problem.
I want to understand which marks you care about before talking about the expected result. Some may improve while others remain. If you’ve already applied a cleaner or stain remover, share the product name so that information is part of the plan.
Getting ready for a deck-cleaning visit
Ask what to move and where to put it. Chairs, cushions, planters, and the grill may need to be out of the work area, but heavy items should be discussed rather than dragged across the boards.
Mention anything stored underneath the deck, along with outdoor outlets, plants, pet access, and water access. Those details can be easy to miss in a photo taken from the back door.
For deck and fence cleaning in the Tri-Cities, send me your address and a few pictures. Include a view of the whole deck, the boards, and any problem spots. If you aren’t sure what the material is, tell me that. I’ll review the details with you and confirm whether a closer look is needed before you decide on the work.

